Andrew James Bread Maker Uživatelský manuál stáhnout pdf (Strana 9)

Inserng the aachment

1. Li up the front end shield.

2. Holding the head, insert it into the inlet.

3. Rotate the head in the same direcon unl a small sound can be

heard. Try to gently rock the head to ensure it is rmly secured in the

correct posion.

4. Place the meat dish on the appliance in the appropriate place.

5. Place the food screw into the head, long end rst by turning the feed

screw slightly unl it is set into the motor housing.

6. Place the cung blade onto the feed screw sha with the blade

facing the front as illustrated. If it is not ed properly then the meat

will not grind correctly.

7. Place the desired cung plate next to the cung blade, ng

protrusions into the slots.

8. Support or press the centre of the cung plate with one nger then

screw the xing ring unl it is ght with the other hand, do not over

ghten it.

9. Place the hopper plate on the head and x it into posion.

10. Place the unit on a at, level and sturdy place.

11. The air passage at the boom and the side of the motor housing

should be kept free and unblocked.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Žádné komentáře

Andrew James Bread Maker Uživatelský manuál Strana 9